Maintaining Your Nylon Whip

Nylon whips are tough.  They don't mind getting wet, dirty, or being dropped all over the place, but they still require some occasional attention.

Making and Replacing the Cracker/Popper

     Crackers, also known as poppers, take a lot of hard knocks each time the whip is cracked, so they will eventually need to be replaced. Luckily, crackers are very easy to make. (video coming soon)

Making and Replacing the Fall

     The fall takes the wear and tear of going supersonic so that the thong, the braided part of the whip, doesn't have to. 
     Nylon falls tend to last quite a long time, but after heavy use, it may fray or even tear if it's used on rough surfaces such as gravel or concrete. (video coming soon)

Maintaining The Thong

     The thong generally doesn't need much attention, but if it gets dirty, you can wash it with a mild soap (i.e., hand soap) and water.  You can scrub out dirt and other debris with a soft bristle brush like a toothbrush. If the whip is not waxed, it will soak up water like a sponge, so be sure to wipe it down as much as possible, and leave it in a clean place to dry.
     If the thong begins to get fuzzy, you can CAREFULLY singe the strands with a lighter. Run it lightly and quickly past the fuzz.

If The Whip Gets Wet...

     No worries, paracord is tough stuff.  Moisture does add a bit of weight on an un-waxed whip, so do be a bit more careful when cracking it.  Waxed nylon whips shrug water off much better. In either case, when you're finished using your whip, you must wipe it down with a clean cloth and leave it somewhere to dry. I recommend laying it down on a grated surface where it can get even ventilation.